Steps
1. Remove the two (T5, M1.4x4) Torx screws that secure the display FPC holder to the system board.
2. Remove the two (T5, M1.4x4) Torx screws that secure the display FPC to the system board.
3. Disconnect the display FPC from the system board and remove the interposer board.
CAUTION:
The pins on the interposer board are very fragile. Do not push or apply pressure to the pins on the
interposer board or perform any action that may scratch the pins, such as rotating/turning the board while
they are in contact with any surface. When handling the interposer board, lift and hold the board from the
edges or the sides.
4. Remove the six (M2.5x5) screws that secure the display hinges to the palm-rest and keyboard assembly.
40
Removing and installing components
To Next Page
Loading...
