2. Install the:
a. base cover
b. battery
c. battery cover
d. SD card
3. Follow the procedure in After working inside your computer.
Solid State Drive
Removing the M.2 Solid State Drive—SSD module
1. Follow the procedures in Before working inside your computer.
2. Remove the:
a. SD card
b. battery cover
c. battery
d. base cover
NOTE: Removal of base cover is required only to access the M.2 SSD module in slot 3, 5 or 6.
3. To remove the M.2 SSD module (Slot 4):
a. Remove the single (M2.0x3.0) screw that secures the SSD assembly to the system [1].
b. Pull the release latch to unlock the SSD assembly [2].
c. Remove the SSD assembly from the system [3].
Removing and installing components
41
To Next Page
Loading...
