Dell S2725DS - Page 64

64 │ Operating your monitor
When the monitor enters the Standby mode, the following message appears:
If you press any button other than the power button, the following messages
appear depending on the selected input:
No DP Cable
The display will go into Standby mode in 4 minutes.
www.Dell.com/support/S2725DS
If an HDMI or DisplayPort cable is not connected, the following dialog box appears.
The monitor enters Standby mode after four minutes if left at this state.
No DP Cable
The display will go into Standby mode in 4 minutes.
www.Dell.com/support/S2725DS
or
No HDMI 1 Cable
The display will go into Standby mode in 4 minutes.
www.Dell.com/support/S2725DS
or
No HDMI 2 Cable
The display will go into Standby mode in 4 minutes.
www.Dell.com/support/S2725DS