Name: Dell S4810
Brand: Dell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

15 SCG1000 Force10 S4810 Configuration Guide

4.3 Revert to default VLAN ID on switch and arrays

Once DCB is disabled on the switch, the EqualLogic arrays will no longer use the VLAN ID that was

configured when DCB was enabled. The arrays will revert to the default or native VLAN. Therefore, a valid

VLAN must be configured for all host servers, switches, and EqualLogic array members. A valid VLAN can

use the default or native VLAN ID (typically 0 or 1) or a specific VLAN can be configured (for example,

VLAN 100). If a non-default VLAN is configured, then any ports connected to the arrays must be

configured as “untagged”.

Use the steps below to configure the native VLAN on the switch.

FTOS#configure

FTOS(conf)#no interface vlan vlan-id

4.4 Save configuration

FTOS#copy running-config startup-config

4.5 Reload

FTOS#reload

System configuration has been modified. Save? [yes/no]yes

Proceed with reload [confirm yes/no]yes

Note: The switch will reboot.

4.6 Verify DCB status

FTOS#show dcb

Figure 2 Screen shot of show DCB

4.7 Configure additional switch

Repeat the commands from section 4 to disable DCB on any additional switches.

Other manuals for Dell S4810

Questions and Answers:

Need help?

Do you have a question about the Dell S4810 and is the answer not in the manual?

General