3. To remove the WLAN card:
a. Remove the single M2L3 screw that secures the tab to the WLAN card [1].
b. Lift the tab that secures the WLAN card [2].
c. Disconnect the WLAN cables from the connectors on the WLAN card [3].
d. Slide the WLAN card from the connector on the system board [4].
Installing the WLAN card
1. Install the WLAN card to the connector on the system board.
2. Connect the WLAN cables to the connectors on the WLAN card.
3. Place the securing tab on the WLAN card and tighten the M2L3 screw on the computer.
4. Install the:
a. base cover
b. keyboard
c. optical drive
d. battery
5. Follow the procedure in After working inside your computer.
Memory modules
Removing the memory module
1. Follow the procedure in Before working inside your computer.
24
Disassembly and reassembly
To Next Page
Loading...
