Installing the power connector
1. Insert the power connector into the slot on the computer.
2. Secure the power connector to the computer by using the single [ M2x2 (Big head 07)] screw.
3. Route the power connector cable.
4. Install the:
a. system board
b. system fan
c. WLAN Card
d. memory module
e. heat sink
f. hard drive assembly
g. base cover
h. keyboard
i. optical drive
j. battery
5. Follow the procedure in After working inside your computer.
Ensamblaje de la pantalla
Removing the display assembly
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. optical drive
c. keyboard
d. base cover
e. WLAN card
3. To remove the display assembly:
a. Unroute the WLAN cable [1].
b. Peel the adhesive tape [2].
c. Lift the locking tab [3].
d. Disconnect the eDP cable [4].
38
Disassembly and reassembly
To Next Page
Loading...
