3 Align the notch on the solid-state drive with the tab on the solid-state drive slot.
4 Slide and insert the tab solid-state drive into the solid-state drive slot [1].
5 Tighten the captive screw that secures the thermal plate to the palmrest and keyboard assembly [2].
6 Replace the single (M2x3) screw that secures the thermal plate to the palmrest and keyboard assembly [3].
Next steps
1 Install the battery
2 Install the base cover
3 Install the optical drive
4 Install the micro SD card
5 Follow the procedure in after working inside your computer
34
Removing and installing components
To Next Page
