Dell Vostro 3581 - Installing the Power Button Board

Steps
1 Open the latch and disconnect the power button board cable from the system [1].
2 Peel the conductive tape o the power button board [2].
3 Remove the single (M2x2) screw that secures the power button board to the palmrest and keyboard assembly [3].
4 Lift the power button board, along with the cable o the palmrest and keyboard assembly [4].
Installing the power button board
Steps
1 Place the power-button board into the slot on the palmrest and keyboard assembly [1].
2 Replace the single (M2x2) screw that secures the power button board to the palmrest and keyboard assembly [2].
3 Ax the conductive tape to the power button board [3].
4 Slide the power button cable to the system board and close the latch to secure the cable [4].
64
Removing and installing components