Installing the heatsink
Steps
1 Place the heatsink on the system board and align the screw holes on the heatsink with the screw holes on the system board [1].
2 Replace the three (M2x3) screws that secure the heatsink to the system board [2].
3 Tighten the screws in the order of the callout numbers [1, 2, 3, 4] as indicated on the heatsink. [3].
Next steps
1 Install the battery.
2 Install the base cover.
3 Install the optical drive.
4 Install the SD card.
5 Follow the procedures in After working inside your computer.
VGA cable
Removing the VGA cable
Prerequisites
1 Follow the procedure in before working inside your computer
2 Remove the micro SD card
3 Remove the optical drive
46
Removing and installing components
To Next Page
