About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
Steps
1. Lift the protective tape and the Mylar that covers the solid-state drive slot.
2. Slide the 2280 solid-state drive into the solid-state drive slot.
3. Replace the screw (M2x3) that secures the 2280 solid-state drive to the system board.
4. Affix the Mylar and the protective tape over the solid-state drive.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in Before working inside your computer.
CAUTION:
Removing the coin-cenn battery resets the BIOS setup program's settings to default. It is
recommended that you note the BIOS setup program's settings before removing the coin-cell battery.
2. Remove the base cover.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
Disassembly and reassembly
21
To Next Page
Loading...
