NOTE: A Torx #5 (T5) screwdriver is necessary to remove the six screws (M2x3, Torx 5).
2. Place your thumbs and fingers into the recess at the top edge of the base cover.
3. Use both thumbs to pry the base cover in order to release it from the palm-rest and keyboard assembly.
NOTE: Do not pull on or pry the base cover from where the display assembly hinges are, doing so may damage the base
cover.
4.
Move your hands to both sides of the base cover and lift the base cover off the palm-rest and keyboard assembly.
5. Loosen the captive screw (M1.6x2) that secures the battery-connector bracket to the system board.
6. Unhook and lift the battery-connector bracket off the system board.
7. Use the pull tab on the battery-power cable to disconnect the battery cable from the battery connector (JBATT1).
Installing the base cover
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
Figure 14. Installing the base cover
Removing and installing Field Replaceable Units (FRUs)
37
To Next Page
Loading...
