9. Replace three screws (M1.6x2.5) that secure the camera and display-assembly cable holder to the system board.
10. Connect the camera cable to the camera cable connector (JCAM1) on the system board.
11. Connect the display cable to the display cable connector (JEDP1) on the system board.
12. Align the screw holes on the display-assembly cable bracket with the screw holes on the system board and tighten the three
captive screws (M1.6x2) to secure the bracket.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
System board
Removing the system board
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working in your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive from M.2 slot, whichever is applicable.
4. Remove the battery.
5. Remove the fans.
6. Remove the heat sink.
About this task
The following image indicates the connectors and components on your system board.
Figure 45. System-board connectors
1.
Wireless-card slot 2. Camera-assembly cable connector (JCAM1)
3. Display cable connector (JEDP1) 4. Capacitive touch function row cable connector (JTF1)
5. Left-speaker cable connector (JSPKR1) 6. Left-fan cable connector (JFAN1)
64 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
