NOTE: Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly before
replacing the screws.
4. Connect the battery cable to the connector (JBATT1) on the system board.
5. Line up the battery-connector bracket over the battery connector on the system board.
6. Slide the hook at the end of the battery-connector bracket under the system board. Ensure the hook fits into the underside
of the system board.
7. Tighten the captive screw (M1.6x2) to secure the bracket to the system board. Ensure that the stud on the system board
fits into its opening on the battery-connector bracket.
Figure 25. Battery-connector bracket
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the M.2 2230 solid state drive
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working in your computer.
2. Remove the base cover.
About this task
NOTE:
Depending on the configuration ordered, your computer may support an M.2 2230 solid state drive or an M.2 2280
solid state drive.
NOTE: A thermal pad is adhered to the system board under the M.2 solid state drive. If the thermal pad is inadvertently
separated from the system board during the removal or replacement of the M.2 solid state drive, readhere the thermal pad
to the system board.
46 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
