Figure 21. Lift the battery at an angle less than 30 degrees
6. Slide the battery towards the back and lift the battery off the palm-rest and keyboard assembly.
Installing the battery
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
CAUTION:
Removing the battery resets the BIOS setup settings to default. It is recommended that you note the
BIOS setup settings before removing the battery.
The following images indicate the location of the battery and provide a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
43
To Next Page
Loading...
