Palm-rest assembly
Removing the palm-rest assembly
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working in your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the display assembly.
5. Remove the system board.
NOTE: The system board can be removed with the following components attached:
● Heat sink
● Fans
● Solid state drive
6.
Remove the power button with fingerprint reader.
7. Remove the keyboard.
About this task
The following images indicate the location of the palm-rest assembly and provide a visual representation of the removal
procedure.
Figure 61. Removing the palm-rest assembly
Removing and installing Field Replaceable Units (FRUs)
81
To Next Page
Loading...
