Figure 30. Insert the M.2 solid state drive shield
4. Replace the screw (M2x3) that secures the M.2 solid state drive shield to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the M.2 2280 solid state drive
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working in your computer.
2. Remove the base cover.
About this task
NOTE:
Depending on the configuration ordered, your computer may support an M.2 2230 solid state drive or an M.2 2280
solid state drive.
NOTE: A thermal pad is adhered to the system board under the M.2 solid state drive. If the thermal pad is inadvertently
separated from the system board during the removal or replacement of the M.2 solid state drive, readhere the thermal pad
to the system board.
NOTE: This procedure applies only to computers shipped with an M.2 2280 solid state drive.
The following images indicate the location of the M.2 2280 solid state drive and provide a visual representation of the removal
procedure.
50
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
