Figure 31. Removing the M.2 2280 solid-state drive
Steps
1. Remove the screw (M2x3) that secures the M.2 solid state drive shield to the system board.
2. Lift the M.2 solid state drive shield off the system board.
3. Slide the M.2 2280 solid state drive out of the solid state drive slot.
4. Lift the M.2 2280 solid state drive assembly off the system board.
NOTE:
A thermal pad is adhered to the system board under the M.2 solid state drive. If the thermal pad is inadvertently
separated from the system board during the removal or replacement of the M.2 solid state drive, readhere the thermal
pad to the system board.
Figure 32. Thermal pad
Removing and installing Field Replaceable Units (FRUs)
51
To Next Page
Loading...
