Figure 37. Removing the right fan
Steps
1. Open the latch on the left-fan cable connector, use the pull tab of the left-fan cable to disconnect it from the connector
(JFAN1) on the system board.
2. Remove the two screws (M1.6x2.5) that secure the left fan to the system board.
3. Lift the left fan off the system board.
4. Open the latch on the right-fan cable, use the pull tab of the right-fan cable to disconnect it from the connector (JFAN2) on
the system board.
5. Remove the two screws (M1.6x2.5) that secure the right fan to the system board.
6. Lift the right fan off the system board.
Installing the fans
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
55
To Next Page
Loading...
