About this task
The following images indicate the location of the power button with fingerprint reader and provide a visual representation of the
removal procedure.
Figure 53. Removing the power button with fingerprint reader
Steps
1. Open the display assembly to a 90-degree angle and place the computer on the edge of a flat surface. Ensure to maintain
the angle throughout the removal process to minimize the risk of damaging the thin display panel when applying torque to
install and remove screws from the computer.
2. Remove the four screws (M1.4x2) that secure the power-button bracket to the palm-rest and keyboard assembly.
3. Lift the power-button bracket off the palm-rest and keyboard assembly.
4. Lift the palm-rest and keyboard assembly slightly.
5. Unthread the power-button cable through the opening on the upper-left side of the palm-rest and keyboard assembly and
remove the power button with fingerprint reader.
Installing the power button with a fingerprint reader
CAUTION: The information in this installation section is intended for authorized service technicians only.
72 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
