Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the power button with fingerprint reader and provide a visual representation of the
installation procedure.
Figure 54. Installing the power button with fingerprint reader
Steps
1. Open the display assembly to a 90-degree angle and place the computer on the edge of a flat surface. Ensure to maintain
the angle throughout the installation process to minimize the risk of damaging the thin display panel when applying torque to
install and remove screws from the computer.
2. Thread the power-button cable through the opening on the upper-left side of the palm-rest and keyboard assembly.
3. Place the power button with fingerprint reader on the palm-rest and keyboard assembly.
4. Align the screw holes of the power button with the screw holes of the power-button bracket.
5. Replace the four screws (M1.4x2) that secure the power-button bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
Removing and installing Field Replaceable Units (FRUs)
73
To Next Page
Loading...
