Figure 28. Installing the M.2 2230 solid-state drive
Steps
1.
NOTE:
A thermal pad is adhered to the system board under the M.2 solid state drive. If the thermal pad is inadvertently
separated from the system board during the removal or replacement of the M.2 solid state drive, readhere the thermal
pad to the system board.
Figure 29. Thermal pad
Align the notch on the M.2 2230 solid state drive with the tab on the solid state drive slot on the system board.
2. Slide the M.2 2230 solid state drive into the solid state drive slot.
3. Insert the tab of the M.2 solid state drive shield into the peg on the system board.
Removing and installing Field Replaceable Units (FRUs)
49
To Next Page
Loading...
