Figure 23. Installing the battery
Steps
1. Align the edge of the battery at an angle so that the cutouts on the battery fit into the hooks on the palm-rest and keyboard
assembly. Align the two screw holes on the battery with the screw holes on the palm-rest and keyboard assembly as well.
Figure 24. Align the battery
2. Lower the battery to the palm-rest and keyboard assembly until it fits into the battery section of the palm-rest and keyboard
assembly.
3. Replace the six screws (M1.6x2.5) to secure the battery to the palm-rest and keyboard assembly.
Removing and installing Field Replaceable Units (FRUs)
45
To Next Page
Loading...
