Figure 34. Thermal pad
Align the notch on the M.2 2280 solid state drive with the tab on the solid state drive slot.
2. Slide the M.2 2280 solid state drive into the solid state drive slot.
3. Insert the tab of the M.2 solid state drive shield into the peg on the system board.
Figure 35. Insert M.2 solid state drive shield
4. Replace the screw (M2x3) that secures the M.2 solid state drive shield to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
53
To Next Page
Loading...
