Figure 39. Installing the right fan
Steps
1. Align the screw holes of the left fan with the screw holes of the system board.
2. Replace the two screws (M1.6x2.5) that secure the left fan to the system board.
3. Connect the left fan cable to the connector (JFAN1) on the system board and close the latch to secure the cable.
4. Align the screw holes of the right fan with the screw holes of the system board.
5. Replace the two screws (M1.6x2.5) that secure the right fan to the system board.
6. Connect the right fan cable to the connector (JFAN2) on the system board and close the latch to secure the cable
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
57
To Next Page
Loading...
