Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the connectors and components on your system board.
Figure 49. System-board connectors
1.
Wireless-card slot 2. Camera-assembly cable connector (JCAM1)
3. Display cable connector (JEDP1) 4. Capacitive touch function row cable connector (JTF1)
5. Left-speaker cable connector (JSPKR1) 6. Left-fan cable connector (JFAN1)
7. Haptic-module cable connector (JTP1) 8. M.2 solid-state drive slot
9. Battery cable connector (JBATT1) 10. Keyboard-control board cable connector (JKB1)
11. Right-fan cable connector (JFAN2) 12. Right-speaker cable connector (JSPKL1)
13. Power-button connector (JFP1)
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
68
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
