Removing the Hard Drive | 37
2 Using the pull-tab, disconnect the hard-drive cable from the system board.
3 Peel the mylar from the hard-drive assembly.
4 Remove the screws that secure the hard-drive assembly to the palm-rest assembly.
5 Lift the hard-drive assembly, along with its cable, out of the palm-rest assembly.
6 Lift the hard-drive assembly, along with its cable, out of the palm-rest assembly.
7 Disconnect the interposer from the hard-drive assembly.
1screws (4) 2mylar
3 hard-drive assembly 4 hard-drive cable
5pull-tab
1 hard-drive assembly 2 interposer
book.book Page 37 Wednesday, June 20, 2012 2:23 PM