22
Operation
7 Operation
7.1 Safety instructions
CAUTION!
Damage or faulty measuring results through improper operation!
Improper operation can cause damage.
Therefore:
The selection of the sensor from the parameter set of the display unit
must correspond to the serial number of the detector of the detector
head connected under any circumstances.
The sensor must not be damaged or contaminated.
Protect the detector against temperature fl uctuations during
measuring. Make sure that the temperature is constant according
to the specifi cation.
Personal protective equipment
Wear protective clothing when operating the module:
Protective clothes
Safety glasses
Protective gloves
7.2 Functions of DELOLUXcontrol
7.2.1 Overview of confi guration options
The manufacturer programs DELOLUXcontrol in such a way that only the detector heads
supplied can be selected. If another detector head is to be included, the display unit
must be sent to the manufacturer so that the respective detector head can be activated
and the calibration factor can be entered. An arbitrary combination of sensors and display
units is not possible due to the permanently stored calibration values.
The following menu selection results from the maximum equipment (4 detector heads):
To Next Page
Loading...