10
Safety
2 Safety
This chapter gives an overview of all important safety aspects for protection of personnel
as well as safe and trouble-free operation.
2.1 Intended use
The device is exclusively conceived and designed for the use described herein.
NOTE!
DELOLUXcontrol, in combination with the corresponding detector heads,
serves to measure and control the intensity of the polymerization-effective
radiation of a curing lamp. The detector heads are subject to calibration.
Comply with the manufacturer’s instructions and operating instructions of
the lamps to be measured/controlled under any circumstances.
WARNING!
Danger from inappropriate use!
Any application beyond the scope of these operating instructions and/or
use other than intended can lead to dangerous situations.
Therefore:
Use the module for its intended purpose only.
Strictly follow all safety and handling instructions of the adhesives
used.
Strictly follow all safety instructions in chapter 6 Installation and
connection, page 21, chapter 7 Operation, page 22, and chapter 8
Maintenance, page 27.
2.2 Contents of the instructions
Every person, who works with or on the device, must read the operating instructions and
have understood them before working with or on the device. This also applies to persons
who have already worked with such a device or a similar one or who were trained by
the manufacturer.
2.3 Modifi cations and alterations
To avoid danger and ensure optimum performance, no modifi cations or changes may be
made to the device unless these have been expressly approved by the manufacturer.
To Next Page
Loading...