9
General
1.6 Spare parts
WARNING!
Risk of injury from the use of incorrect spare parts!
Incorrect or defective spare parts can cause damage, malfunctions or
complete failure, and can impair safety.
Therefore:
Use only original parts by the manufacturer.
Order spare parts (see chapter 10 Spare parts and accessories, page 30) from
authorized dealers or directly from the manufacturer.
1.7 Disposal
If no return or disposal agreement has been made, recycle the device after proper
disassembly:
Scrap metal material
Dispose of electric components as electronic waste
The customer assumes the duty (§10 para. 2 ElektroG – Electrical and Electronic
Equipment Act) to dispose of the goods delivered in proper form according to the
statutory provisions at his own expense upon end of use (WEEE reg. no. DE 31546579).
Disposal by the manufacturer is possible on request.
1.8 Warranty terms and liability
Refer to the sales documents for the warranty terms.
The technical data relate to measurements at the point of time of goods issue within the
scope of general quality assurance. The values measured were determined under
laboratory conditions and may deviate depending on the conditions of use.
It is the user’s responsibility to test the suitability of the device for the intended purpose by
considering all specifi c requirements.
1.9 CE conformity
The declaration of conformity is provided in the appendix of these operating instructions
(see chapter 11.1 CE conformity, page 31).
To Next Page
Loading...