11
Safety
2.4 Responsibility of the operator
The device is used commercially. The installer/operator is responsible for the safety of the
system in which the device is integrated. Therefore, the installer/operator of the device is
subject to statutory requirements for occupational safety.
Besides the instructions for occupational safety contained in these operating instructions,
operators must also follow general safety regulations, accident prevention regulations and
environmental protection regulations.
The following requirements apply in particular:
Read these operating instructions carefully and keep them for future consultation.
Pass on these operating instructions to any subsequent owner or user of the device.
The operator is responsible for staying informed of the applicable industrial safety
regulations and conducting a risk assessment to determine additional risks specifi c to
the area where the equipment is to be used. The operator company must address
these risks in the form of work instructions for the operation of the device.
These operating instructions must be kept in the immediate vicinity of the device and
accessible to the persons who work with or on the device at any time.
The directions in the operating instructions are to be followed completely and without
any changes!
The device may only be used if in technically sound and operational condition. If there
are doubts about the operability of the device or signs of fracture or other damage,
operation must be stopped immediately and the device must be sent to the
manufacturer for inspection and repair without delay.
The device must not be used unless the installing and operating procedure and
instructions have been read and understood by the persons using it.
The device must not be operated or connected other than in accordance with the type
plate and the operating instructions!
Comply with prescribed intervals or those specifi ed in these operating instructions for
periodic checks and inspections.
To Next Page
Loading...