19
PROBLEM CAUSE SOLUTION
After grinding, the amount of coee in
the lter does not give the “perfect dose”
The "Smart Tamping Station" needs
cleaning
Carry out cleaning as described in section
“8.3 Cleaning the “Smart tamping sta-
tion””, then repeat the grinding step
The quantity of ground coee needs
adjusting
Adjust the quantity with the relative dial
(B1) following the indications given in
section “The “perfect dose””. If the dial is
already in the MAX position, proceed as
described in section “7. Settings menu” -
“Extra grinding adjustment”
The 2-cup lter is being used Make sure the 2x indicator is on
Over time the burrs wear down
Contact Customer Services
There is ground coee on the cup tray
after using the grinder
During the pressing operationthe tamp-
ing step, the lever was not returned to the
at-rest position.
To tamp the coee correctly:
• Bring the lever fully down;
• Return the lever to the at-rest
position;
• Repeat the tamping stroke, and
when the lever is fully down, remove
the portalter so that the compacted
coee remains smooth and glossy;
• Return the lever to the at-rest
position.
15. STATISTICS
Machine statistics are useful in the event of service being need-
ed. Proceed as follows:
• Access the menu by pressing buttons
1x
(B2) and
(B6)
simultaneously and holding for 3 seconds;
• Turn the dial (B7) to select “Espresso Cool”;
• Press
(B5)
;
• Once you have entered the settings menu, select the de-
sired data by rotating the selection dial as shown in the
following table:
Positioning of dial Counter
Total count of descale cycles
Total count of hot drinks
Total count of cold drinks
• The 1x, 2x, OK, and
indicators show the numbers
of operations:
Control panel indicators Drinks
count
Descale
count
up to 100 up to 1
between
100 and
1000
between 2
and 10
between
1000 and
3000
between 10
and 30
between
3000 and
6000
between 30
and 60
between
6000 and
11000
between 60
and 110
more than
11000
more than
110
• The appliance automatically exits the settings menu after
30 seconds of inactivity.
To Next Page