What to do if Delphi YDT262 shows 'ZERO ANGLE ERROR' message?
If the 'ZERO ANGLE ERROR' message appears on your Delphi Controller, it means the pump drive shaft was not stationary when the unit was powered on. Ensure the pump is stationary when powering on the unit. If the problem persists, switch the controller off, wait a few seconds, and then switch it back on.
What to do if Delphi YDT262 Controller powers up, but unexpected messages/characters appear?
If your Delphi Controller powers up but displays unexpected messages or characters, switch it off, wait a few seconds, and then switch it back on.
Why is my Delphi Controller YDT262 not powering up?
If your Delphi Controller YDT262 is not powering up, check the electrical supply. Also, verify that the 120/240V selector switch is correctly set for your local power supply. Finally, inspect the 3 fuses.
How to fix unstable variation screen on Delphi Controller or when it shows 0 degrees?
If the variation screen on your Delphi Controller shows 0 degrees or is not stable at 360 degrees, check that the encoder is securely connected. Also, check that the piezo sensor and cable are securely connected. If the issue continues, switch the controller off, wait a few seconds, and then switch it back on.
General| Brand | Delphi |
|---|---|
| Model | YDT262 |
| Category | Controller |
| Language | English |
To Next Page
