Trigno™ Wireless Biofeedback System
- 28 -
Maintenance and Care
Trigno Sensors
Trigno sensors are encased in a sealed polycarbonate enclosure. The following
points should be kept in mind when handling the sensors.
All sensors should be visually inspected before each use to ensure that
no mechanical deterioration has occurred.
The sensors can be cleaned with isopropyl alcohol swabs. Ensure that
the sensor contacts remain clean at all times for proper operation.
While the sensors are sealed and are water-resistant, these should
never be completely submerged in any liquid.
The sensor contacts are made of pure silver and are quite soft. Care
should be taken to preserve the integrity of these contacts. Do not
scrape or dent these contacts.
Handle the sensors with care: do not drop them on the ground or
step on them.
Do not submerge the sensors in any liquid under any circumstance.
The sensors contain sensitive electronic circuitry. Static discharges
and intense electro-magnetic fields should be avoided to prevent the
risk of irreparable damage to the sensors.
Trigno Base Station
The Trigno System is designed to provide years of reliable service when proper
care is followed. While the Base Station enclosure is made of durable plastic,
the following points should be kept in mind during its use and handling:
The device and its accessories should be visually inspected before
every use to ensure that no mechanical deterioration has occurred.
The Base Station can be easily cleaned with isopropyl alcohol swabs if
necessary. Do not expose the base station to any liquid. It is not a
sealed device.
The units not be dropped or be subjected to excessive forces of impact
or accelerations.
The recharging Base Station is not water-resistant. Under no
circumstance should this unit be exposed to water or any other type
of liquids.
To Next Page
Loading...
