Delta 36-5000 T2 Series - Extension Wings

EXTENSION WINGS
For the 36-5000 T2 and 36-5100 T2.
Hardware Bag “C, D, G”
Figure 8
Figure 9
ASSEMBLY
3
3
LEFT EXTENSION LEFT EXTENSION
WING WING
RIGHT EXTENSION RIGHT EXTENSION
WING WING
RULER RULER
PC10
HP7
HP14
HP15
HP7
HP24
PC10
1. Attach the left extension wing
PC10
[3] to the front rail
using two 5/16-18 x 1-1/8 inch Flat Countersunk Hex
Screws
HP15
and 5/16-18 Hex Flange Nuts
HP14
.
2. Attach the left extension wing
PC10
[3] to the rear rail using
two 5/16-18 x 7/8 Hex Screws w/ Split Lock Washers
HP7
and 5/16-18 Hex Flange Nuts
HP14
.
3. Attach the left side extension wing
PC10
[3] to the front and
rear rails using four 5/16 18 x 1 1/8 inch Flat Countersunk
Hex Screw
HP15
and 5/16 18 hex ange nuts
HP14
.
4. Attach the left side extension wing
PC10
[3] to the side of
the saw table using three 5/16 18 x 7/8 inch hex head
screws with Split Lock Washers
HP7
. See Figure 10.
5. Lay the two remaining extension wings
PC10
[3] upside
down on the saw table. Place the two wings adjacent to
each other, so the holes patterns match. Fasten the two
wings together using three 5/16 18 x 7/8 inch hex head
screws with Split Lock Washers
HP7
and 5/16 18 hex ange
nuts
HP14
.
6. Turn the two wings fastened together over and fasten
them to side of the saw table using three 5/16 18 x 7/8
inch hex head screws with Split Lock Washers
HP7
. See
Figure 9.
7. Secure the 2 joined Extension Wings
PC10
to the front rail
using four 5/16-18 x 1-1/8 inch Flat Countersunk Hex
Screws
HP15
and 5/16-18 Hex Flange Nuts
HP14
.
8. Secure the 2 joined Extension Wings
PC10
to the rear rail
using four 5/16-18 x 7/8 Hex Screws w/ Split Lock Washers
HP7
and 5/16-18 Hex Flange Nuts
HP14
.
NOTE: Use a ruler to make sure the top edges of the wings are
flush with the top of the tabletop. See Figure 8.
NOTE: There are four 5/16-18 Set Screws
HP24
for the cast iron
extension wing for the 36-5100 T2. Two Set Screws for each cast
iron Extension Wing. The set screws are used to adjust the level.
See Figure 9.
19