Delta 36-650 - BLADE TILTING AND RAISING HANDWHEEL

9
4. WITH A MINIMUM OF TWO PEOPLE,
CAREFULLY TURN THE SAW AND STAND UPRIGHT
AS SHOWN IN FIG. 10. Carefully push down on the top
of the saw until the stand legs adapt to the floor surface
and firmly tighten all stand mounting hardware.
Fig. 10
BLADE TILTING AND
RAISING HANDWHEEL
2. Assemble the blade raising handwheel (A) Fig. 12, to
the front of the saw in the same manner.
1. Place blade tilting handwheel (A) Fig. 11, onto shaft
(B). Make certain slot (C) in handwheel is engaged with
roll pin (D) on the shaft. Place a 10mm flat washer onto
shaft (B) Fig. 11. Thread locking knob (E) Fig. 12, onto
shaft (B) Fig. 11.
Fig. 11
D
B
C
A
Fig. 12
E
A