24
Chapter 3 Operation
z
z
04: Site fault detection enable/disable
Parameter 2: Enable or disable site fault detection. You may choose the
following two options:
ENA: Site fault detection enable
DIS: Site fault detection disable(Default)
z
z
05: Autonomy limitation setting
Parameter 2: Set up backup time on battery mode for general outlets.
0-999: setting the backup time in minutes from 0-999 for general outlets on
battery mode.
DIS: Disable the autonomy limitation and the backup time will depend on
battery capacity. (Default)
Note: When setting as “0”, the backup time will be only 10 seconds.
To Next Page
Loading...
