26
Chapter 3 Operation
Parameter 2: Set Input Waveform Sensitivity.
St1: Input voltage waveform detection is highly sensitive. (Default)
St2: Input voltage waveform detection is middle sensitive.
St3: Input voltage waveform detection is low sensitive. (use with generators
or Step wave input)
z
z
09: LCD display backlight setting
Parameter 2: Set up the working mode for the LCD display backlight.
Aon: LCD display backlight is on all the time.
Aut: LCD display backlight will be off after pressing the buttons 60 seconds.
UPS mode switch will wake up LCD backlight for 20 seconds. (Default)
z
z
00: Exit Setting
Exit the setting mode.
Steps for setting programmable outlet
Step 1:
Before entering setting mode, the UPS should be
in Stand-by mode (off-charging) and make sure the
battery is connected. The LCD display is shown as
right.
To Next Page
Loading...
