5 Temperature Measurement Module DVP 04TC-E 2
4. Next, let’s
take 5.8.1 Thermocouple temperature measurement system
as example.
Step 1: Select “#1 Thermocouple Type”.
Step 2: Check “Write Register” to generate TO instruction. Set the condition as “LD M1002”,
Step 3: Set CH1 ~ CH4 as “J Type”
Step 4: Click “Preview” to check if the generated program codes are correct.
Step 5: Click “Add to List” to display the instruction codes in “Instruction List”. The setup of CR#1 is completed.
Step 1
Step 2
Step 3
Step 5
Step 4
5. Setting up CR#2 is similar to the setup of CR#1.
Step 1: Select "#2 CH1 Average Time”
Step 2: Check “Write Register” to generate TO instruction. Set the condition as "LD M1000”.
Step 3: Set the set value as “K10” and number of data as “1”.
Step 4: Click “Preview” to check if the generated program codes are correct.
Step 5: Click “Add to List” to display the instruction codes in “Instruction List”. The setup of CR#2 ~ CR#5 is
completed.
Step 1
Step 5
Step 2
Step 3
Step 4
6. Setting up CR#6 ~ CR#9 is similar to the setup of CR#2 ~ CR#5.
Step 1: Select "#6 Average Celsius Temperature Measured at CH1”
Step 2: Check “Read Register” to generate FROM instruction. Set the condition as "LD M1000”.
Step 3: Set the register for storing data as “D20” and number of data as “4”.
Step 4: Click “Preview” to check if the generated program codes are correct.
DVP-ES2 Module Manual
5-17
To Next Page
Loading...
