5 Temperature Measurement Module DVP04TC-E2
Step 5: Click
“Add to List” to display the instruction codes in “Instruction List”. The setup of CR#6 ~ CR#9 is
completed.
Step 1
Step 2
Step 3
Step 4
7. The setup of other CR parameters can follow the steps illustrated above.
8. After you complete all the setups, click on “OK” to return to the “Auxiliary Design of Extension Module” window
and continue to set up other modules.
9. After you complete the setups of all the modules, click on “OK” to generate the program below.
10. If you need to add in other control programs, you can edit the program directly in the ladder diagram window in
WPLSoft.
DVP-ES2 Module Manual
5-18
To Next Page
Loading...
