To Next PageTo Next Page
Need help?Do you have a question about the Delta MS210 and is the answer not in the manual?
Explains the meaning of safety alert symbols used in the manual.
Outlines fundamental safety principles for operating power tools.
Emphasizes reading the manual and using certified safety gear.
Advises on appropriate clothing and maintaining a clean work environment.
Stresses keeping tools in good condition and checking for damaged parts.
Details how to avoid unintentional machine startup.
Covers correct assembly, obtaining advice, and wiring codes.
Focuses on blade types, sharpness, and securing the workpiece.
Addresses avoiding overreaching, standing on machine, and unattended operation.
Highlights securing the workshop and staying alert during operation.
Details electrical requirements and extension cord usage.
Provides the machine's electrical specifications (voltage, frequency).
Explains the importance and procedure for grounding the machine.
Provides a chart for selecting the correct gauge of extension cords.
Describes the saw's cutting capabilities and specifications.
Guides on how to unpack and clean the new machine.
Instructions for installing the table lock handle.
Steps to position the rotating table to the 90-degree position.
How to move the cutterhead to its upper position for transport.
Explains how to securely mount the miter saw.
Defines the danger zone on the saw table and warns against placing hands there.
Details how to start and stop the miter saw using the switch trigger.
Instructions for securing the switch to prevent unauthorized use.
Guides on setting the table for various miter angles.
Explains how to read and use the angle indicator and scale.
How to adjust the angle indicator for accuracy.
Procedure for securing the cutterhead for transport.
Describes the function of the rear support bar as a carrying handle.
Steps to ensure the saw blade is parallel to the table slot.
How to set the fence perpendicular to the saw blade.
Limits blade travel to prevent contact with machine surfaces.
Provides guidance on performing cuts and general usage tips.
How to attach an auxiliary fence for specific cuts.
Examples of cutting common lumber sizes and pipe.
Proper methods for cutting aluminum with the miter saw.
How to position bowed workpieces for safe cutting.
Initial steps for cutting crown mouldings.
How to use filler blocks for precise crown moulding joints.
Techniques for cutting moulding for corners.
Step-by-step guide on how to replace the saw blade.
Recommended blade types, sizes, and safety precautions.
How to inspect and replace motor brushes.
Information on purchasing accessories for the saw.
Contact information for service, parts, and warranty support.
General