Delta VFD007FP4EA-41 - Page 138

Chapter 10 Digital Keypad|CFP2000 Series
10-6
Display Icon
Display item
1. Parameter Setup
Press ENTER key to select.
Press Up/Down key to select
parameter group.
Once a parameter group is selected,
press ENTER key to go into that group.
For example: Setup source of master frequency command.
Once in the Group 00 Motor Drive Parameter,
Use Up/Down key to select parameter 20:
Auto Frequency Command.
When this parameter is selected, press
ENTER key to go to this parameter’s setting
menu.
Use Up/Down key to choose a setting.
For example: Choose “2 Analogue Input, then
press the ENTER key.
A
fter pressing the ENTER key, an END will be
displayed which means that the paramete
r
setting is done.
2. Copy Parameter
Press ENTER key to go to 001~004:
content storage
4 duplicates are provided
The steps are shown in the example below.
Example: Saved in the motor drive.
1 Go to Copy Parameter
2 Select the parameter group which needs to
be copied and press ENTER key.
1 Select 1: Save in the motor drive.
2. Press ENTER key to go to “Save in the
motor drive” screen.