Delta VFD007FP4EA-41 - Page 154

Chapter 10 Digital Keypad|CFP2000 Series
10-22
14. Application Selection List
Select”
Macro / User Define
Macro” then set relevant
parameters in”Application
Selection List”.
Application Selection List is the collection focusing on common used
parameters for industry application, which is providing user the required
parameter groups according to application; hence it also can change the
value of the modified parameters to achieve a more rapid and convenient
parameter settings.
Application Selection List operation associated charts is as below showing.
Application Selection Application Selection List Parameter Changed List
Pr.
location
Group 13
(parameter setting)
Main page 14 Main page 15
Function
Enter & edit parameter
location
Set the value of parameter
Parameter changed list
reference & Set the value
of parameter
Operation
Set parameter 13-00=
2~10(2~10:application
selection;1:user
parameter)
 In application
selection list，press
ENTER 2 times it will
show the related
parameters.
 Use up/down key to
select application
selection list，then
press ENTER to set
parameter value.
 In parameter changed
list，press ENTER2
times it will enter the
changed list.
Disable
Edit the value of
parameter
Edit the location of
parameter
Edit the location of
parameter
Into the Application Selection page(during Pr.13-00≠0)，then press ENTER
into Application Selection List，it will show the corresponding settings
according to application list (13-00)，and then press ENTER key to see the
user-defined or other application parameter groups,the parameter setting is
the same as the general case, you can press the up/down key to select the
parameters you want to change.
Operation Steps:
1. Choose”Parameter setting”group 13 then select the application which
you want in” Application Selection List”,the setting list is as below:
13-00=0 :Disabled (Macro function close)
=1 :User Parameter
=2 :Compressor
=3 :Fan
=4 :Pump
=5~9 :Reserve
=10 :AHU
2. After selecting application，Pr.13-01~99 will display the related
Application
Selection
(Group 13)
Parameter
Changed List
(Main page 15)
Application
Selection List
(Main page 14)