Chapter 10 Digital Keypad|CFP2000
10-23
parameters (it will have a little number of parameters different according
to the different kind of application list you select.There are 24 default
parameters in compressor application; if you select Fan application,
there are 33 default parameters.)
3. For example, if you select Compressor application:
13-00=2 (Compressor)
13-01~13-24 (Compressor related parameters)
4. The showing in Application Selection List is Compressor
List PrNum=024(Compressor related parameters)
Compressor
No. Pr. Explanation Settings
1 00-11 Control of Speed Mode System Definition
2 00-16 Load Selection System Definition
3 00-17 Carrier Frequency Factory Setting
4
00-
0
Source of Master Frequency Command
（AUTO）
System Definition
5
00-21
Source of the Operation Command
（AUTO）
System Definition
00-22 Stop Method System Definition
7 00-23 Control of Motor Direction System Definition
8 01-00 Max. Operation Frequency Factory Setting
9 01-01 Output Frequency of Motor 1 Factory Setting
10 01-02 Output Voltage of Motor 1 Factory Setting
11 01-03 Mid-point Frequency 1 of Motor 1 Factory Setting
12 01-04 Mid-point Voltage 1 of Motor 1 Factory Setting
13 01-05 Mid-point Frequency 2 of Motor 1 Factory Setting
14 01-06 Mid-point Voltage 2 of Motor 1 Factory Setting
15 01-07
Min. Output Frequency of Motor 1
Factory Setting
16 01-08 Min. Output Voltage of Motor 1 Factory Setting
17 01-11 Output Frequency Lower Limit System Definition
18 01-12 Accel. Time 1 System Definition
19 01-13 Decel Time 1 System Definition
To Next Page
Loading...
