Chapter 10 Digital Keypad|CFP2000 Series
10-24
20 03-00 Analog Input Selection (AVI) System Definition
21 03-01 Analog Input Selection (ACI) System Definition
22 05-01 Full-load Current of Induction Motor 1(A) Factory Setting
23 05-03 Rated Speed of Induction Motor 1 (rpm) Factory Setting
24 05-04 Pole Number of Induction Motor 1 Factory Setting
5. When user select” Application Selection List” (e.g. Compressor), drive
will show the related parameters in above table according to user ‘s
selection, the settings content can be divided into”System Definition”
and”Factory Setting”. ”System Definition”means
drive will load the
commonly used value settings in compressor application;”Factory
Setting”means the default setting of drive. User can edit the parameter
value no matter the setting is”System Definition” or”Factory Setting”.
6. User can edit or change the parameter space(max. to 99,Pr.13-01~99)
for Compressor in” Application Selection List”,if you want to add 2
spaces after default parameter(Pr.13-01~24) for Compressor,it needs to
select No.25 & 26 parameter space(Pr.13-25 and Pr.13-26) then enter
7.11(Pr.07-11) and 7.33(Pr.07-33)
separately (Please pay a special
attention,if you key in 0.00 in any position, it will be identified as the final
parameters of this application parameter)，after changing the Application
Selection List will have 26 parameter locations for Compressor can be
selected.
No. Pr. Explanation Setting
25
07-11
Number of Times of Auto
Restart After Fault
System
Definition
26 07-33 Auto restart internal of Fault
System
Definition
Please follow the setting process below to set the User Defined application
selection (Pr.13-00=1):
If user select User Parameter (Pr.13-00=1), but there is no any definition for
parameter location (Pr.13-01~99), it is not allow to check in Application
Selection List page, but also cannot enter next page when press ENTER.If
To Next Page
Loading...
