Delta VFD007FP4EA-41 - Page 159

Chapter 10 Digital Keypad|CFP2000
10-27
e.g. adjust 13-01 Application Parameter 1 value from 0.11(00-11 Control of
Speed Mode) to 0.02(00-02 Parameter Reset).
UseST key to select 01：Application
Parameter 1，then press
to adjust
parameter value.
UseST key to adjust the parameter 0.02，
then press
.
z In Fan application, when adding new parameter space
(Pr.13-34~99)，it needs to pay attention that if you key in 0.00 in any
position, it will be identified as the final parameters of this application
parameter.
z In addition, whether the user has edited or changed the Application
Selection List, when switching to other application, it will load the
initial value of this application definition.
z Application Selection List needs to set in parameter group 13.Set
Pr.13-00≠0, the Application Selection List is enable.
z Set Pr.13-00=1, User Parameter is enable.
z User sets parameter Pr.13-01 ~ 99 according to the function demand,
when the value is 0.00, it means there is no preset or user defined
parameters. Select the desired parameter location then press
ENTER, the settings will record to parameters Pr.13-01 ~ 99.
z The settings of user parameter is the same as general parameter, use
the up /down, left and right keys to speed up the setting, please note
that the read-only parameters can not be set.
z If the changed parameter settings need to change again, it needs to
back Pr.13-01~99 for modification.
z If you want to remove the parameter when the parameter has been
set, you must to remove from the last parameter. For example, if you
set 5 parameters from Pr.13-01 to Pr.13-05, if you want to remove
Pr.13-02; it needs to remove from Pr.13-05, Pr.13-04 and Pr.13-03 in
order.