Chapter 11 Summary of Parameter SettingsCFP2000 Series
76: Safety Torque Off (STO)
77: Channel 2 (STO2~SCM2) internal hardware error
(STL2)
78: Channel 1 and Channel 2 internal hardware error
(STL3)
79: U phase over current (Uocc)
80: V phase over current (Vocc)
81: W phase over current (Wocc)
82: U phase output phase loss (OPHL)
83: V phase output phase loss (OPHL)
84: W phase output phase loss (OPHL)
90: FStp Inner PLC function is forced to stop
99: TRAP CPU command error
101: CANopen software disconnect1 (CGdE)
102: CAN open software disconnect2 (CHbE)
103: CANopen synchronous error (CSyE)
104: CANopen hardware disconnect (CbFE)
105: CANopen index setting error (CIdE)
106: CANopen slave station number setting error
(CAdE)
107: CANopen index setting exceed limit (CFrE)
111: Internal communication overtime error (ictE)
0~65535(refer to bit table for fault code)
0~65535(refer to bit table for fault code)
0~65535(refer to bit table for fault code)
0~65535(refer to bit table for fault code)
Electronic Thermal Relay
Selection 2 (Motor 2)
0: Inverter motor (with external forced cooling)
1: Standard motor (so motor with fan on the shaft)
2: Disable
Electronic Thermal
Characteristic for Motor 2
0: Warn and keep operation
1: Warn and ramp to stop
2: Warn and coast to stop
3: No warning
Frequency Command for
Malfunction
Output Frequency at Malfunction
Output Voltage at Malfunction
DC Voltage at Malfunction
Output Current at Malfunction
IGBT Temperature at Malfunction
Capacitance Temperature at
Malfunction