Delta VFD007FP4EA-41 - Page 201

Chapter 11 Summary of Parameter SettingsCFP2000 Series
11-27
Pr.
Explanation
Settings
Factory
Setting
09-27
~
09-29
Reserved
09-30
Communication Decoding
Method
0: Decoding Method 1 (20xx)
1: Decoding Method 2 (60xx)
1
09-31
Internal Communication Protocol
0: Modbus 485
-1: Internal Communication Slave 1
-2: Internal Communication Slave 2
-3: Internal Communication Slave 3
-4: Internal Communication Slave 4
-5: Internal Communication Slave 5
-6: Internal Communication Slave 6
-7: Internal Communication Slave 7
-8: Internal Communication Slave 8
-9: Reserved
-10: Internal Communication Master
-11: Reserved
-12: Internal PLC Control
0
09-32
Reserved

09-33
PLC command force to 0
0~FFFF
0000h
09-34
Reserved
09-35
PLC Address
0: Disable
1~254
2
09-36
CANopen Slave Address
1~127
0
09-37
CANopen Speed
0: 1M bps
1: 500K bps
2: 250K bps
3: 125K bps
4: 100K bps (Delta only)
5: 50K bps
0
09-38
Reserved
09-39
CANopen Warning Record
bit 0: CANopen Guarding Time out
bit 1: CANopen Heartbeat Time out
bit 2: CANopen SYNC Time out
bit 3: CANopen SDO Time out
bit 4: CANopen SDO buffer overflow
bit 5: Can Bus Off
bit 6: Error protocol of CANopen
bit 7: Reserved
bit 8: The setting values of CANopen indexes are fail
bit 9: The setting value of CANopen address is fail
bit10: The checksum value of CANopen indexes is fail
Read
only
09-40
CANopen Decoding Method
0: Delta defined decoding method
1: CANopen DS402 Standard
1
09-41
CANopen Communication
Status
0: Node Reset State
1: Com Reset State
2: Boot up State
3: Pre Operation State
4: Operation State
5: Stop State
Read
Only
09-42
CANopen Control Status
0: Not ready for use state
1: Inhibit start state
2: Ready to switch on state
3: Switched on state
4: Enable operation state
7: Quick Stop Active state
13: Err Reaction Activation state
Read
Only