Chapter 12 Description of Parameter Settings|CFP2000 Series
12.1-09-12
PC or PLC command
Handling time
of the AC drive
Response Delay Time
Pr.09-09
Response Message
of the AC Drive
RS-485 BUS
Main Frequency of the Communication
Factory Setting: 60.00
Settings 0.00~599.00Hz
When Pr.00-20 is set to 1 (RS485 communication). The AC motor drive will save the last
frequency command into Pr.09-10 when abnormal turn-off or momentary power loss. After
reboots the power, it will regard the frequency set in Pr.09-10 if no new frequency command is
inputted. When frequency command of 485 is changed (the source of frequency command
needs to be set as MODBUS), this parameter is also be changed.
Block Transfer 1
Block Transfer 2
Block Transfer 3
Block Transfer 4
Block Transfer 5
Block Transfer 6
Block Transfer 7
Block Transfer 8
Block Transfer 9
Block Transfer 10
Block Transfer 11
Block Transfer 12
Block Transfer 13
Block Transfer 14
Block Transfer 15
Block Transfer 16
Factory Setting: 0000h
Settings 0~FFFF
There is a group of block transfer parameter available in the AC motor drive (Pr.09-11 to
Pr.09-26). Through communication code 03H, user can use them (Pr.09-11 to Pr.09-26) to save
those parameters that you want to read.
~
Reserved
Communication Decoding Method
Factory Setting: 1
Settings 0: Decoding Method 1 (20xx)
To Next Page