Delta VFD007FP4EA-41 - Page 56

Chapter 5 Main Circuit Terminals|CFP2000 Series
5-5
Frame A
Main circuit terminals:
z If you install at Ta 40°C above environment, please select copper wire
which have voltage rating 600V and temperature resistant 90°C or above.
z If you install at Ta 40°C environment, please select copper wire which
have voltage rating 600V and temperature resistant 75°C or 90°C.
z For UL installation compliant, you have to use copper wires when
installation, the wire gauge is based on temperature resistant 75°C which
is according to the requirements and recommendations from UL. Do not
reduce the wire gauge when using higher temperature wire.
R/L1, S/L2, T/L3,
Models Max. Wire Gauge Min. Wire Gauge Torque
VFD007FP4EA-52S
10 AWG [5.3mm
2
]
12 AWG
[3.3mm
2
] 8kg-cm
[6.9lb-in.]
[0.78Nm]
VFD015FP4EA-52S
VFD022FP4EA-52S
VFD037FP4EA-52S
VFD040FP4EA-52S
10AWG
[5.3mm
2
]
VFD055FP4EA-52S
VFD075FP4EA-52S
U/T1, V/T2, W/T3, B1, B2,
Models Max. Wire Gauge Min. Wire Gauge Torque
VFD007FP4EA-52S
10 AWG [5.3mm
2
]
12 AWG
[3.3mm
2
]
M3.5
10kg-cm
[8.7 lb-in.]
[0.98Nm]
VFD015FP4EA-52S
VFD022FP4EA-52S
VFD037FP4EA-52S
VFD040FP4EA-52S
10AWG
[5.3mm
2
]
M4.0
18kg-cm
[15.6 lb-in.]
[1.77Nm]
VFD055FP4EA-52S
VFD075FP4EA-52S
，DC-，DC+
Models Max. Wire Gauge Min. Wire Gauge Torque
VFD007FP4EA-52S
10 AWG [5.3mm
2
]
12 AWG
[3.3mm
2
]
M4.0
18kg-cm
[15.6 lb-in.]
[1.77Nm]
VFD015FP4EA-52S
VFD022FP4EA-52S
VFD037FP4EA-52S
VFD040FP4EA-52S
10AWG
[5.3mm
2
]
VFD055FP4EA-52S
VFD075FP4EA-52S
; It needs following additional terminal when wiring. The additional
terminal dimension should comply with the following figure 1.
; After crimping the wire to the ring lug (must UL approved), UL and CSA
approved R/C(YDPU2) heat shrink tubing rated min 600Vac insulation
shall be install over the live part.
A
(MAX)
B
(MAX)
C
(min)
D
(MAX)
d2
(min)
E
(min)
F
(min)
W
(MAX)
T
(MAX)
12.1 3.6 6.1 5.6 4.3 7.0 6.1 7.3 1.0
Unit: mm