Delta VFD9A0MS43ANSHA User Manual

Chapter 11 Summary of Parameter SettingsMS300 (High Speed Model)
11-12
Pr. Explanation Settings
Factory
Setting
52: Output for communication card control
66: SO output logic A
67: Analog input level reached output
68: SO output logic B
73: Over torque 3
74: Over torque 4

02-18
Multi-function output direction
0000h~FFFFh (0: N.O.; 1: N.C.)
0000

02-19
Terminal counting value attained
(returns to 0)
0~65500 0

02-20
Preliminary counting value attained
(not return to 0)
0~65500
0

02-21
Digital output gain (DFM)
1~22 1

02-22 Desired frequency attained 1 0.0~1500.0 Hz
600.0/
500.0

02-23
The width of the desired frequency
attained 1
0.0~1500.0 Hz 20.0

02-24
Desired frequency attained 2 0.0~1500.0 Hz
600.0/
500.0

02-25
The width of the desired frequency
attained 2
0.0~1500.0 Hz 20.0

02-34
Output frequency setting for
multi-function output terminal
0.0~1500.0 Hz
(Motor speed when using PG Card)
0.0

02-35
External operation control selection
after reset and activate
0: Disable
1: Drive runs if run command exists after reset
0

02-47
Zero-speed Level of Motor 0~65535 rpm 0
02-50
Status of multi-function input
terminal
Monitor the status of multi-function input terminals
Read
only
02-51
Status of multi-function output
terminal
Monitor the status of multi-function output
terminals
Read
only
02-52
Display external multi-function input
terminals used by PLC
Monitor the status of PLC input terminals
Read
only
02-53
Display external multi-function
output terminals used by PLC
Monitor the status of PLC output terminals
Read
only
02-54
Display memory of frequency
command used by external terminal
Read only
Read
only

02-81
EF active when terminal count value
attained
0: Terminal count value attained, no EF display
1: Terminal count value attained, EF active
0

Delta VFD9A0MS43ANSHA Specifications

General

Brand	Delta
Model	VFD9A0MS43ANSHA
Category	Controller
Language	English